Conrad Hartz Ventriloquist Figure
There are some figure makers today that are throw backs to a time gone by and Conrad Hartz is one of those few. He still makes his figures using basswood and hand carves them just like the old makers.
I am happy to present to you all this fine little fellow which was crafted by Conrad earlier in his career. This creation was done in the early manner of Frank Marshall’s earliest style figures. The head was made in two halves, front and rear, they separate on the sides of the head with the carved ears being part of the back half. Conrad supplied side to side non self centering eyes with the teeter totter cross bar and slot jaw. His controls back at this time were made of brass. He now uses plastic. He cut out on the head stick for the mouth controller.
I find that this cheeky style boy is very much in the style of Frank Marshall. I also feel it is one of Conrad’s better renditions. I was not able to see a date inside the head but I am assuming it is from the late 70’s or early 80’s. His wig and paint are all original as well as the very cartoony style hands. A very fine figure indeed!!
Click here to see the Conrad Hartz Ventriloquist Figure
Dan
www.ventriloquistcentral.com
***************************************************
All writings here are copyrighted by Dan Willinger and Ventriloquist Central. You may not use them without written permission but you may link to the posts or give out a link to the posts.
If you enjoyed this post, make sure you subscribe to my RSS feed!
September 25th, 2008 at 9:47 pm
Conrad’s jaw levers are indeed plastic. He makes them from toothbrushes. His side-to-side eye controls, however, are brass.
His internal mechanics are a combination of brass, plastic, and steel. He uses household items wherever he can. Patio door runners for pulleys, knittnig needles for axles, cabinet hinges for the jaw, etc. Conrad’s mechanics today are the smoothest and quietest that you will find.